Camera Calibration

AIM discussions, tips and tricks, plug-ins, Q & A

Moderator: mnoschang

Camera Calibration

Postby Gary_B » Sun Mar 10, 2013 6:54 am

Hi i am currently trying to get a very accurate calibration using the blob finder tool I'm getting an x-y ratio of 1.03 and the max error is 10.27mm w/o perspective correction. this means when i run my program the robot is picking the component up off center is there anyone who could help me to improve the calibration or have any ideas on the best way to correct the center offset thanks
Regards
Gary_B
Gary_B
 
Posts: 6
Joined: Mon Dec 10, 2012 2:33 pm

Return to AIM

Who is online

Users browsing this forum: No registered users and 1 guest

cron