Controller Abilities

Adept SmartController CX, assistance, configuration, etc

Controller Abilities

Postby Chancejacoby » Fri Sep 18, 2009 6:20 am

Good Morning,

I am currently designing the first robotic cell that is to be implimented into the company. The robot is going to load 1 of 56 different types of tubes into an end former and then unload it. My biggest concern at this moment is, how the programming will work this out. If a PLC sends a signal via Ethernet IP on which tube is to be run. Will the Controller be able to load that tubes program, its points, change the characteristics in the vision software on its own. I am currently counting the need for 3 cameras, 2 for the tube load stations, and 1 for the quality check after the cycle is complete.

I want to be sure that i can avoid as many issues as possible before i start placing orders.

Any comments or suggestions would be greatly appreciated.

Thank you,

Chance
Chancejacoby
 
Posts: 1
Joined: Mon Aug 17, 2009 10:15 am

Return to SmartController CX Robot Control

Who is online

Users browsing this forum: No registered users and 1 guest

cron