DIP Switch Settings

Adept SmartController CX, assistance, configuration, etc

DIP Switch Settings

Postby KevinS » Wed Jun 23, 2010 5:24 am

Pictured below are the configuration DIP switch settings used by the V+ system.

SW1 switch.jpg
Switches
SW1 switch.jpg (4.75 KiB) Viewed 8916 times

Dip SwitchesCX.jpg
Settings
Dip SwitchesCX.jpg (67.42 KiB) Viewed 8916 times

Note: SW1 is configured by Adept to a default configuration listed in row #5 (OFF-OFF-OFF-OFF) to use the CompactFlash and NVRAM settings. Adept recommends that the user maintain his default SW1 configuration for normal SmartController operation. The default NVRAM settings are auto boot, ethernet, and use default IP address.

The default IP address for the controller is located on a label on the bottom side of the controller chassis.
KevinS
 

Return to SmartController CX Robot Control

Who is online

Users browsing this forum: No registered users and 1 guest