Encoder Type

Adept SmartController CX, assistance, configuration, etc

Encoder Type

Postby Gary_B » Thu Jan 31, 2013 3:20 am

Hi
I was wondering for connecting an external encoder to the smart-controller cx is there a certain type of encoder needed the one i currently have is a two track encoder but doesn't have an i track as shown in the wiring diagram.
Gary_B
 
Posts: 6
Joined: Mon Dec 10, 2012 2:33 pm

Re: Encoder Type

Postby KevinS » Fri Feb 01, 2013 3:01 pm

Gary_B,

The i+ and i- signals are used for zero index checking. They are not required for the belt encoder connection to function. You should only need the 6 remaining wires. ( A+, A-, B+, B-, 5 volt, Ground)

After wiring the encoder you can verify its function by clicking on the Encoder button available through the SmartController object of the Adept ACE interface, see image below. If you spin the encoder you should see the position count change.

Encoder.PNG
Encoder.PNG (27.36 KiB) Viewed 9447 times


Additional information can be found in the SmartController User's Guide around page 57
http://www1.adept.com/main/KE/DATA/Cont ... rCX_UG.pdf
KevinS
 


Return to SmartController CX Robot Control

Who is online

Users browsing this forum: No registered users and 1 guest