Page 1 of 1

Programing Omron E5CC

PostPosted: Tue Nov 28, 2017 1:38 am
by yoramdar
hi
I need help with sending command to an E5CC trough .NET visual c#.
Working with the PDF it seems that I can't send write command to the device.
I can read but not set any parameters to it.
I try to set the SV parameter. Can't find the register # to write into.
Working with four-byte mod address #0106 dose nothing.

Thanks

Re: Programing Omron E5CC

PostPosted: Fri Dec 01, 2017 12:35 am
by Guenter Grass
Hi,

this is the support forum for the OMRON - Adept products, formerly Adept Technology. We do not provide support for the OMRON E5CC.

Best Regards
G√ľnter