Page 1 of 1

How to Save the program in V+ 11.4

PostPosted: Sat May 20, 2017 7:43 am
by heyz1985
Hello all,
I am a new for the V+ program ,need your help ,thanks.
Such as some program has run in robot a MV10 controller ,then found some problem in this program ,after editing the program called test.pg in V+ system (blue monitor Screen), when used the storep test.pg= test,always alarm error ,how to save the edited program ? thanks.

Re: How to Save the program in V+ 11.4

PostPosted: Sat May 20, 2017 9:23 am
by brianch
It would help if you said what error you were getting.
Possibly the problem is *Program already exists*. In that case, this might fix it.

FRENAME test.bk1 = test.pg
STOREP test.pg= test

See if that helps.
Here is a link to the Operating System Reference Guide, just in case.
http://www1.adept.com/main/KE/DATA/V%20 ... RGTOC.html

Re: How to Save the program in V+ 11.4

PostPosted: Sat May 20, 2017 5:29 pm
by heyz1985
Thanks.
Here is the error message as below ,also review the attachments .
File or subdirectory name error

Re: How to Save the program in V+ 11.4

PostPosted: Sat May 20, 2017 9:03 pm
by heyz1985
brianch wrote:It would help if you said what error you were getting.
Possibly the problem is *Program already exists*. In that case, this might fix it.

FRENAME test.bk1 = test.pg
STOREP test.pg= test

See if that helps.
Here is a link to the Operating System Reference Guide, just in case.
http://www1.adept.com/main/KE/DATA/V%20 ... RGTOC.html




Thanks.
Here is the error message as below ,also review the attachments .
File or subdirectory name error

Re: How to Save the program in V+ 11.4

PostPosted: Mon May 22, 2017 7:40 am
by brianch
One problem is V+ enforces the eight dot three naming convention for local disks so disk_search is way to long of a name for V+. Try calling your program something else that is eight characters or less in length.

Re: How to Save the program in V+ 11.4

PostPosted: Sat Jun 10, 2017 6:27 am
by heyz1985
brianch wrote:One problem is V+ enforces the eight dot three naming convention for local disks so disk_search is way to long of a name for V+. Try calling your program something else that is eight characters or less in length.


Thanks ,Brianch .
the file has already running in the MV controller, If the problem is the file name is too long ,it should be can't running ,now just edit this file in MV controller and can't save it .I don't know why.

Re: How to Save the program in V+ 11.4

PostPosted: Wed Jun 14, 2017 12:23 am
by Guenter Grass
In V+ file names can't be longer than 8 characters. File extensions can be up 3 characters.

I think you are mixing up program names with file names.

Please check the files on your controller with the command FDIR. It shows all files and subdirectories. You will not find any filename with more than 8 characters.

If you want to see the names of all programs in RAM use the command DIR. Programs can have names up to 15 characters.

Best Regards
Günter