Factory calibration cobra 600 with MV controller

A1, XL1, XL3, MV Cobra, and A6 Robots

Moderator: MikeM

Factory calibration cobra 600 with MV controller

Postby Rich Northen » Thu Dec 15, 2011 8:39 am

Where can I download the calibration proceedure cobra 600 with MV controller.
Rich Northen
Maintenance Dept.
Cardinal Health
Jacksonville Texas
903-541-2983
Rich Northen
 
Posts: 1
Joined: Thu Dec 15, 2011 7:16 am

Re: Factory calibration cobra 600 with MV controller

Postby DaveS » Thu Dec 15, 2011 9:56 am

Hello Rich,
In order to perform a factory calibration you need have a Self-Support Kit (SSK). The SSK contains a calibration bar and the software required to complete the factory calibration. Without the kit you would need to schedule a support engineer to come to your facility to do the calibration or send the robot in to have it done. Usually a factory calibration is only required to be completed on a VME Cobra when the Robot Signature Card (RSC) in the back of the robot has been and the original RSC data is not available to re-install on the RSC.

What is the problem you are having with the robot?

Dave S
DaveS
 


Return to Adept MV Robots

Who is online

Users browsing this forum: No registered users and 1 guest