EXC connector CN3 pinout?

Moderator: MikeM

EXC connector CN3 pinout?

Postby Jfet » Tue Feb 01, 2011 10:53 am

Does anyone have a description or link to the pinout of connector CN3 on the Adept EXC controller? It is not mentioned in the manual and I have not been able to find anything online. I am curious if this connector might allow a step/direction type input to the controller and is undocumented? It is labeled pulse out on both controllers I have.

Thanks!
Jfet
 
Posts: 3
Joined: Thu Jan 27, 2011 5:47 am

Re: EXC connector CN3 pinout?

Postby DaveS » Tue Feb 15, 2011 12:52 pm

Sorry for the delay in the reply to your question, seems the process to notify moderators of new posts is broken.

I have attached a copy of the CN3 Pin Out
Attachments
CN3 Pin out.txt
(1.07 KiB) Downloaded 1305 times
DaveS
 

X,Y, AND Z CONTROLLER BOARD EXC CONNECTIONS

Postby haroldallen » Wed Jul 20, 2011 3:37 pm

Which connectors do the controller boards plug into on the main board inside a stand alone EXC controller. I had to replace a card and I did not notice their is 4 possible connectors (J1-J4). I am assumming it goes J1-X axis, J2-Y axis, and J3-Z axis...can anyone help me out?
haroldallen
 
Posts: 3
Joined: Wed Jul 20, 2011 11:36 am


Return to MV Controls

Who is online

Users browsing this forum: No registered users and 1 guest