This post is concerning an EXC stand alone unit.

Moderator: MikeM

This post is concerning an EXC stand alone unit.

Postby haroldallen » Wed Jul 20, 2011 3:45 pm

Which connectors do the controller boards plug into on the main board inside a stand alone EXC controller. I had to replace a card and I did not notice their is 4 possible connectors (J1-J4). I am assumming it goes J1-X axis, J2-Y axis, and J3-Z axis...can anyone help me out?
haroldallen
 
Posts: 3
Joined: Wed Jul 20, 2011 11:36 am

Re: This post is concerning an EXC stand alone unit.

Postby DaveS » Thu Jul 21, 2011 10:16 am

It has been awhile since I have worked on these controllers but if I recall correctly you connect the Amps starting from edge of the board and move inward (i.e. J1 amp is connected to the first port at the edge of the board)
DaveS
 

Re: This post is concerning an EXC stand alone unit.

Postby haroldallen » Thu Jul 21, 2011 10:22 am

I was correct, it is J1-X, J2-Y, and J3-Z. I appreciate the help!
haroldallen
 
Posts: 3
Joined: Wed Jul 20, 2011 11:36 am

Re: This post is concerning an EXC stand alone unit.

Postby KevinS » Thu Jul 21, 2011 5:15 pm

Documentation is also available from the Adept Docuemt Library archived documents, please see the links below.

Doucument Library:
http://www1.adept.com/main/KE/DATA/adep ... _index.htm

Archived Manuals:
http://www1.adept.com/main/KE/Data/MENU ... ed_men.htm

Adept Modules Instruction Handbook Volume 1, EXC/EXA Controller interface:
http://www1.adept.com/main/KE/Data/Arch ... XCVOL1.PDF
KevinS
 


Return to MV Controls

Who is online

Users browsing this forum: keebler64 and 2 guests