MV-8 swap with MV-10

Moderator: MikeM

MV-8 swap with MV-10

Postby alesf » Wed Mar 23, 2016 5:42 am

Hi all, we have Staubli RX170HP with CS7 controller. CS7 controller is equipped with MV-8 with SIO, MI-6, ABC, 030. We have a spare MV-10 controller with AWCII 060, MI-6e.
My question is can this two be swapped ? What would be the correct procedure to make it work with Staubli robot ?
Thanks for the answer.
alesf
 
Posts: 3
Joined: Mon Mar 21, 2016 12:56 am

Re: MV-8 swap with MV-10

Postby alesf » Fri Apr 01, 2016 3:44 am

Hi, just asking is this forum dead ? Or is still functional ?
alesf
 
Posts: 3
Joined: Mon Mar 21, 2016 12:56 am

Re: MV-8 swap with MV-10

Postby MikeM » Fri Apr 15, 2016 12:17 pm

The forum is still functional.
In regards to your question about the Staubli RX170, you would need to address the question to Staubli. While both the MV-8 and MV-10 controllers are certainly manufactured by Adept Technology, the system was configured and sold by Staubli and there are a number of differences that are particular to the Staubli setup, including the software and configuration.
MikeM
 
Posts: 1
Joined: Mon Jan 05, 2009 10:31 am

Re: MV-8 swap with MV-10

Postby alesf » Sun Apr 17, 2016 11:04 pm

Ok
alesf
 
Posts: 3
Joined: Mon Mar 21, 2016 12:56 am


Return to MV Controls

Who is online

Users browsing this forum: No registered users and 0 guests

cron