Changing the Lamp on the High Power Indicator

Your Adept system is equipped to detect the potentially dangerous condition of a burned out High Power indicator. If this lamp is burned out, you cannot enable High Power until the lamp is replaced. To replace the High Power indicator bulb, do the following:

Turn off the controller and disconnect system power.
Remove all cables from the back and side of the CIP.
Remove the CIP from its mounting location.
Remove the six screws from the front of the CIP as shown in the figure below. Also remove the MCP bypass plug retaining screw.

Carefully pull the front panel away from the body of the CIP. You will encounter considerable resistance. There are several plug-type connectors that must be disconnected as you pull the front panel away from the body of the CIP. Pull the panel as straight as possible.
Locate the lamp body on the back side of the front panel. Turn the lamp body approximately 20° in either direction. Then, pull straight back.
With the lamp body free, you can now remove the old lamp and insert a new one.
Push the lamp body straight into the lamp housing receptacle. Make sure the contacts on the lamp body are properly oriented. See figure below.

Push the CIP front panel into the CIP body. Be sure to align all plug-type connectors.
Replace the six front panel screws and the MCP bypass plug retainer screw.
Reinstall the CIP in its mounting.
Reconnect the CIP cables. (Make sure the JDIO1 to JDIO4 cables are correctly reinstalled.)