Python Error

Adept Cobra i600 and i800 SCARA robots

Python Error

Postby blakeb » Thu Aug 22, 2013 8:12 am

I didn't see a section for the Python modules, so I started this topic here. I have configured a 4-axix, XYZT, robot using 4 python modules. However, I am unable to start the calibration step, because of an E1 error on the z and theta axis. I am unable to enable power because of this error. I have gone through the setup several times. The manual doesn't say what would cause the error. Any help?
Posts: 1
Joined: Fri Feb 01, 2013 2:01 pm

Re: Python Error

Postby seank » Thu Aug 22, 2013 9:35 am

In ACE, if you open up the robot object, under Control-Hardware Diagnostics you will be able to see the faults. E1 means that there is an encoder fault. From here, you can reset it. Then in under Motor 1, you can open up the calibration section and reteach/home/calibrate the axis.
2013-08-22_093411.png (42.24 KiB) Viewed 11464 times
Sean Kelly
Applications Engineer
Adept Technology, Inc.
Posts: 12
Joined: Fri Jul 29, 2011 10:46 am

Return to Cobra i600/i800

Who is online

Users browsing this forum: No registered users and 1 guest